CheckSwing

The Premier Baseball Social Network for Players, Coaches, Scouts, and Umpires

hi all, I am a new bat manufacturer (small operation ran out of my garage) and am look for dimensions on different bat models. I have searched everywhere on the internet and was hoping somewhere would be able to help. I do all my turning by hand, so dimension breakdown would be more benfical then actual templates, but templates would work as well. Any help would be greatly appreciated.

thank you

Joe

3Ten Bats

Views: 213

Replies to This Discussion

When I started out, I ordered one unfinished bat in each of the models I was interested in - from a company I buy billets from - and measured.  Then I finished and used those bats, so it wasn't much of an expense.  That being said, I have dimensions for some models which I'd share with you.  Private message me and I'll set you up if I have what you want.

Chris

hi do you cup bats I have 4 blem bats that need cupping if you do could i ship to you to get the job done

I don't, Edward.

Joe, most commonly used bats these days have the following diameters : Knob 2", handle at a point 6" from the knob  15/16", barrel 2 7/16" to 2 1/2" at a point 2" from the bat end. Bats now vary very little and tend to copy metal and composite models. Tom at Barnstable Bat Company

RSS

Get Your CheckSwing Badge !

Loading…

Events

Audio

Loading…

© 2019   Created by Kyle Grucci.   Powered by

Badges  |  Report an Issue  |  Terms of Service

--> \ua!-- G +1 All Pages Above Sign-In\ud\ud-->